24V | MEANWELL DRIVER | IP20 | 150W

This Meanwell is very suitable as a 24V power supply for LED strips and LED modules and other constant voltage indoor applications. It can be loaded up to a maximum of 150 watts. In addition, there is an LED that indicates the status (on/off). The output voltage can be adjusted slightly with the potentiometer (+V ADJ). It is recommended to check the output voltage before connecting the 24V from the power supply. With the potentiometer, the voltage should then be set as accurately as possible to 24V. If you do not have this option, make sure that you do not touch the potentiometer. The amplifier is enclosed in a metal housing. All sides (except the bottom) must be kept clear due to the heat that can be released. The bottom can be mounted directly on material, but not on top of it. This serves as a cooling surface. The amplifier can be mounted at 2 points (from above, top left and bottom right) with 3mm screws/bolts. Please note: No cables are included. You must connect the 110V/220V cable and 24V cable yourself. How to connect them is described above.

-Input voltage: 85 - 132VAC (110V mode), 170 - 264VAC (230V mode) or 240 - 370VDC (in 230V mode) -Output voltage: 24V DC -Maximum output current: 6.5 Protection against short circuit, overload and overvoltage (on the output) The other specifications are clearly described in the datasheet. You can find this under the Downloads tab. -L (Phase wire, brown wire) -N (Neutral wire, light blue wire) -Earth (Yellow-green wire, connect this for more safety if possible) -2x -V (This is the GND/ground/minus of the 24V) -2x +V (This is the plus of the 24V)